Latest
Midea shows air-liquid data center cooling at DCW Middle East
Image: Midea Building Technologies

Midea shows air-liquid data center cooling at DCW Middle East

Midea Building Technologies used Data Center World Middle East 2026 in Abu Dhabi, which closed on 18 November, to show a range of chillers and coolant distribution units (CDUs) aimed at AI data centers in hot climates. The company’s pitch is that Gulf operators face two pressures at once: denser racks driven by AI workloads, and ambient temperatures above 50°C that push conventional cooling hard.

Midea’s stand ran under the theme “Cooling AI. Delivering Certainty.” It covered both air-cooled and liquid-cooled setups. Exhibits included an air-cooled screw chiller, air-cooled and water-cooled magnetic centrifugal chillers, and CDUs.

Scale model of Midea's air-liquid converged data center cooling system with chillers, dry coolers, CDUs and fan walls
Image: Midea Building Technologies

Air first, liquid when you need it

Midea’s main message is an air-liquid converged design. High-efficiency air-cooled chillers act as the primary cooling source, paired with CDUs and fan walls. The company says the setup lets operators adjust the air-to-liquid ratio over time. That means it can serve the air-cooled designs that still dominate the region, then scale up to higher-density liquid-cooled loads later. Midea also says supplying the whole chain from one vendor speeds up deployment and cuts upfront capital expenditure.

The company says its air-cooled chillers are built to run continuously at ambient temperatures up to 55°C with no loss of capacity. The AirBoost Inverter Air-Cooled Screw Chiller was the featured model:

  • It uses R1234ze(E) refrigerant, with a global warming potential below 1.
  • It uses permanent magnet synchronous inverter screw compressors, which Midea rates at up to 97% efficiency.
  • Midea lists zero-inrush startup, active harmonic filtering (THDi below 5%) and full-load recovery within 120 seconds.
  • Its aluminum microchannel heat exchangers were tested for 9,000 hours in salt spray, which Midea says suits dusty and coastal sites.

Two CDUs for different densities

On the secondary side, Midea presented two CDUs. The ultra-high-capacity model is rated at 2.6MW, which Midea describes as industry-leading. It has redundant, hot-swappable components and predictive control that holds temperature within ±0.5°C, so cooling keeps running during maintenance.

The Magnetic CDU targets air-liquid hybrid sites. It combines magnetic bearing compression with free cooling and carries an IP67 rating for dusty environments. Its modular, prefabricated design cuts time-to-market by more than 20%, according to Midea. The company also says it takes up 70% less floor space than conventional water chillers, which frees room for IT equipment.

Keynote and supply chain roundtable

Midea also took part in the conference programme. Marwan AlObaidi, Regional Director of Data Center and Applied Business at Midea Building Tech., gave a keynote titled “Cooling the Data Center Evolution: From Air to Liquid, From Cloud to AI”. It covered how the industry is moving to liquid cooling in extreme regional climates.

The company also hosted a roundtable called “Delivering the Pipeline: Supply Chain Realities for Data Centre Cooling in the Gulf”. Data center experts and ecosystem partners discussed project-lifecycle problems, including early procurement planning, supply chain localization, locking in design decisions, and system integration and commissioning. Midea said the aim was to give operators practical ways to improve delivery certainty in the Gulf.